Stabiliser Stopper

Similar to GMK and TX Stabiliser Stoppers, these are 3D printed wedges for your Clip-in Stabilisers and have been designed specifically for Cherry Clip-Ins. 

Pack of 30x Stabiliser Stoppers

• 30x Stabiliser Stopper Wedges
  
• Material: PLA using a 0.10mm layer height
• Colour: Black

There are 2 ways to install these wedges: the Traditional or the Alternate way. The Alternate way is good for those that struggle handling tiny pieces. 

Traditional:
1. Use scissors to separate the Wedges

2. Carefully pick up a piece and Insert into the Stabilser Clip. The wider piece is at the top. Push with slight force

Alternate:

1. Slot a Wedge into the Stabiliser Clip without separating from the pack. 

2. While still attached, push down on the individual wedge to secure it in place and pull side-ways to rip it apart. 

Take care when removing from stabilisers once installed.

Although the design was printed vertically to increase strength, there is still a very small chance the Stoppers will snap in half during removal. This is a limitation of FDM printing. 

To reduce the risk of damage gently wiggle while pulling or remove the stopper from the top of the PCB.